Newbie from the bluegrass state

[stewart jordan]

Hope too gather some good info from others who have attempted the conversions. My current project is a 66 chevy2 i'm wanting to do a 6.0 turbo swap. In the planning gathering parts stages now. Still undecided on whether to leave efi or carb it. So far i have installed a new front clip to make room for the new power plant. Any help or suggestions will be greatly appreciated during this build.

[Antler]

I'll suggest Fuel Injection. Might be just me, but I love modern performance in an old school shell.

[retrolsx]

with a turbo there is not reason to go with a carb! Where are you at in the swap?

[913]

Stay FI, especially with the turbo setup. Which clip did you go with?

[stewart jordan]

with a turbo there is not reason to go with a carb! Where are you at in the swap?

Actually just in the begining stages as far as motor. Finished the front end swap and getting close on the rear (mini tub). I picked up a 76mm turbo but still doing my research on motor and what all is gonna be involved. Figure if i get a baseline cost on getting it together i can see what upgrades if any can be done the first round.

[stewart jordan]

Stay FI, especially with the turbo setup. Which clip did you go with?

I went with the checkered racing kit. There are better more race specific kits out there just not needed on my set-up. I'm mainly building a driver with a little street/track racing being done on occasion. My opinion their kits are hard to beat for the money for street applications.